Shop presets
Vocal Effect Tutorial - Recording & Mixing Chris Brown in Logic Pro

Vocal Effect Tutorial - Recording & Mixing Chris Brown in Logic Pro

Preset Vocal Dinâmico de R&B - Para Logic Pro X. Add a 2nd preset for 50% off in the cart.Preset Vocal Dinâmico de R&B - Para Logic Pro X. Logic Pro X deal: buy 2 presets, get 1 FREE.

Looking for another sound? See all our vocal sounds by artist and style in one place. Thir13een is not affiliated with any artist named.

Quick answer: To get a smooth, bright R&B vocal like the one in this video, record a clean take, then build a chain in Logic Pro in this order: Channel EQ, Compressor, Pitch Correction, a short delay, then a plate reverb. Watch the video for the full session, then use the steps below as a checklist.

How to record and mix an R&B vocal in Logic Pro

Step 1: Record a clean take

Keep the mic 6 to 8 inches from your mouth and use a pop filter. Set the input level so the loudest note peaks around -12 dB. A clean, quiet take makes every later step easier.

Step 2: Clean up with Channel EQ

Add a high-pass filter near 80 Hz to remove rumble. Cut a little at 300 Hz if the voice sounds boxy. Add a gentle shelf boost above 10 kHz for air. Make small moves, about 2 to 3 dB.

Step 3: Even out the level with the Compressor

Start with a ratio of 3:1 to 4:1 and lower the threshold until the meter shows 3 to 6 dB of gain reduction on the loud words. Use a fast attack and a medium release. The goal is a steady vocal that stays up front.

Step 4: Add Pitch Correction

Open Pitch Correction, choose the song's key and use a medium response time for a natural sound. A very fast response gives the hard, robotic effect. Pick the setting that fits the song.

Step 5: Add delay and reverb

Send the vocal to a bus. Add a short stereo delay (1/8 note) and a plate reverb with a decay under 1.5 seconds. Keep the send low enough that the words stay clear. Add the effects last so they do not blur the lead vocal.

Step 6: Compare and adjust

Play the vocal with the full beat. Raise the vocal until you hear every word, then lower the reverb if it sounds washed out. Check the mix on headphones and on a phone speaker.

Skip the setup: use a ready-made chain

If you do not want to build each plugin by hand, load a finished chain. Our R&B Vocal Preset for Logic Pro X (Dynamic R&B) loads the EQ, compression, pitch and effects in one step, so you only adjust the levels to fit your voice. On GarageBand, use the R&B Vocal Preset for GarageBand. Want several sounds? The Logic Pro X Starter Pack has three. Browse the Logic Pro X vocal presets collection.

Frequently asked questions

What plugins do I need for an R&B vocal in Logic Pro?

You only need stock plugins: Channel EQ, Compressor, Pitch Correction, Delay Designer or Stereo Delay, and ChromaVerb or Space Designer.

Can I do this in GarageBand?

Yes. GarageBand has a vocal EQ, compressor, pitch correction and echo and reverb settings. See Logic Pro vs GarageBand for vocals for the differences.

Will this sound exactly like the song?

No. The artist's voice, mic, room and mix are different from yours. The chain gives you the same style of sound, shaped to your own voice.

Back to the full list: every artist-style vocal guide. Related: How to Get The Weeknd-Style Vocals in Logic Pro and GarageBand and How to Get Chris Brown-Style Vocals in Logic Pro and GarageBand.

Voltar ao blog

Deixe um comentário

Atenção: comentários precisam ser aprovados antes de serem publicados.

Presets Vocais para Logic Pro X